Jinyu menyesuaikan waktu rotary hook

In this video, we will teach you how to readjust the rotary hook timing to avoid the thread brakes and stitch problems on your embroidery machine
we will guide you to know everything about the embroidery business you just
Rotary hook timing on JINYU tubular embroidery machine
How to readjust the Rotary hook timing
Tools needed:
1- Philips screwdriver
2- Slotted screwdriver
3- Small slotted screwdriver
4- Curved screwdriver

Step 1:
a) Remove the bobbin case (bobbin case and the bobbin)
b) Remove the needle plate (three flat screws on top)
c) Remove the rotary hook gourd (tow Philips screw left and right)
d) Remove the rotary hook retaining finger (tow Philips screw down)
Step 2:
Manually rotating the rotary hook clockwise using the black knob right side of the arm
There are three screws holding the rotary hook with the main shaft
a)release The two sunken sekrup pertama -tama tidak kehilangan
b) Turunkan jarum ke 200 derajat (secara manual memutar rotary hook searah jarum jam menggunakan sisi kanan tombol lengan)
c) Turunkan keranjang rotary hook untuk tampilan yang jelas
D) Sekarang periksa posisi antara syal jarum dan rilis rilis
terbaik: (ujungnya tidak bisa di tengah kebutuhan jarum dan tepat di belakang kebutuhannya.
yang third prominent screw not to lose
f) Adjusting the timing
-Move the rotary hook front – back and left – right until
Find the best timing
-now tide the prominent screw first then tide the two sunken screws
g) Back the rotary hook retaining finger to the position then tide it
– (make sure the retaining finger does not tide with the notch)
– (make sure the retaining finger is positioned in the middle of the embroidery needle)
– (put the needle between the retaining jari dan takik kemudian pasang sekrup jari penahan)
h) sekarang pergi ke 200 derajat dan periksa tidak apa -apa lalu kembali posisi jarum ke atas
langkah 3:
i) Pergi ke 100 derajat
j) Kembali Kotak kumparan ke rotary hook
k) KEMBALI Kait rotary lourd
l) Kembali piring jarum